Terminally Grounded
Terminally Grounded provides Automotive Electrical Work on hot rods, street rods, restorations.
02/28/2023
240Z Fuel tank modifications
In tank fuel pump, using a Holley Hydramat and Walbro fuel pump.
The access panel was custom made from Aluminum, and added -6 AN fittings for feed and return.
Sorry for not posting in a while, it's been pretty busy the last few months, but I will be more diligent with updating posts.
I'll have a few more vehicles to start posting about soon, and a pretty big development for Terminally Grounded. :D
11/20/2022
Datsun 240Z ignition coil setup.
A coil near plug ("CnP") setup was built and installed on the L28, using D585 coils. The bracket was custom made from aluminum, and uses 3 of the cam cover bolt locations to secure it. The harness is also custom made and setup to allow the entire coil setup to be removed from the car by disconnecting a single plug for the main power and triggers.
11/17/2022
Main power and ground at the starter and some small chassis ground points.
The small ground points allow for star grounding, and easy to add grounds, along with being able to isolate any particular circuit if need be for diagnostics
The main power is 2AWG from the trunk mounted battery, along with 4 AWG ground connections between the body, frame and engine.
10/21/2022
240Z Crank trigger
This is a 36-1 trigger wheel (sourced from PerfectTuning) adapted to the crank pulley, using spacers to maintain proper torque of the crank bolt which also centers this trigger wheel.
The sensor is mounted to a removable block to make changing belts easy. It does take a few minutes to remove that block, but it will set right back into place when reinstalled, so no worrying about if it's aligned properly.
Click here to claim your Sponsored Listing.