Setup

Set your components up you design ..
Setup for Embedded Solutions .

How to create printed Circuit board "PCB" by using Acid etching method "old school" .

1- Create the PCB Layout of your circuit.
2-Print out the diagram from the software's File menu.
3-Print it out on a glossy paper, such as magazine paper.
4-Once heated, carefully place the iron on top of the paper which is on top of the circuit board.
5-Place the iron there for about 30-45 seconds (depending on your iron).
6-After lifting the iron, put it aside carefully and take the circuit board to your nearest source of water. Be careful, the paper will be hot. The paper should be stuck to the circuit board, don’t rip it out.
7-Start the water flow and hold the circuit board below it. An alternative approach is to immerse the board and paper in hot water for a few minutes (up to 10 minutes).
8-Slowing start taking off the paper and soon all of the paper should come off.
9-Dry the board.
10-Etch the board ,This process removes any unnecessary copper from the board leaving only wiring of the final circuit.
11-Remove the insulating drawing material used.
12- Drill mount points.
13-Mount and solder the electronic components on board.