ISaron Technology

Call or WhatsApp Us on 0508131275

TZONE DIGITAL VEHICLE TRACKING DEVICE

SPECIFICATIONS
Special Features:

Support commands to device via GPRS

Mobile phone Google map

Send GPRS data to IP or DNS

Mileage calculation

4Mb/32Mb Flash Memory

Fuel/oil level detection/Listen-in

OTA: upgrade the firmware via GPRS

Temperature sensors(optional)

SIMCOM GSM module and Sirf-starIII GPS Chipset

Atmel MCU: ATmega128

Track by software/by cell phone

Over-speed , Low power, in / out of Geo-fence alarm

Send gprs data or call the preset number when press the SOS alarm

Trembles alarm; network change alarm

Stop sending gprs data when the engine is off or no tremblesgps trackers

Control or detect the car doors/engine on/off

Cut off engine power Gradually and safely when in urgency

GPRS(TCP/UDP), SMS Support
COST GHC 480.00

FIRE ALARM SYSTERM
Fire Alarm System detects and notifies early signs of fire even before it starts. It can help you reduce the risk of injury or death to employees and visitors as well as minimise damage to your property and disruption to your operations. Our 24 hour monitoring ensures your business is watched over at all times, even during non-business hours.


Our Advanced Conventional Fire Alarm System is designed as per The Fire Protection Authority (NFPA) and is ideal for small to medium sized offices, residential complexes and buildings. Zicom maintains the international quality of installation and after sales services.



Components of Fire Alarm System -

Main Control Panel - The Main Control Panel is the brain of the system. All the detectors are connected to the panel via wired loops. The looping is such that if any detectors fault out - the main panel will give a loop open or short signal. This enables one to know immediately when the Fire Alarm System is not functioning correctly. There are two type of Panel available - 2 Zone Panel and 4 Zone Panel.

Conventional Smoke Detector - The smoke detector, is manufactured according to UL 268 Standards, it senses the prsence of smoke and warns you before the fire starts. These are mounted on ceilings and sometimes even above the ceiling for specific requirements. When it detects smoke an alarm gets generated through the ho**er.

Conventional Heat Detector - The EN-54 approved conventional heat detector is designed with the state of the art combination of "Rate-of-Rise" and "Fixed-Temperature" operation ensures the best quality of heat detection in all environments.

Manual Call Point - Ideally placed at entrance/exit points, this is a manual alarm. When some spots a fir or smoke, one can break the glass cover of the Manual Call Point and an alarm is generated.

Response Indicator - A response indicator is device that gives remote visual indication of the fire alarm going off, if the detectors are placed in areas that are not visible easily.

Ho**er - The ho**er is separately connected the control panel. When a detector goes into an alarm condition, it communicates with the main control panel, which in turn activates the ho**er and a siren is generated.