First Coast Powertrain

59.00 Launch full scan no just a. Code pull not like auto zone we can read your data and see what problem is call today 904-465-5712

Auto Pro Car Care and Restoration on Google Check engine light Diagnosis and repair of all drivability

Understanding addaptive learning we run the program to claear it with a scan tool adaptive leaning wihch clears out all learning and blaks out all the prior adaptives as we doint want the prior learning to be present...

SHIFT ADAPTS

Next, the Garage Shift Adapts must be completed:
1. With engine still running and vehicle still secured, verify transmission fluid temperature is still above 86°F.
2. With engine at idle, shift from REVERSE to DRIVE and leave shift lever in DRIVE for five (5) seconds. After five seconds,
shift back to REVERSE and leave shift lever in REVERSE for five seconds. Perform this procedure twenty (20) times
(R-D-R-D-R-D...). The shift transitions need to be directly between DRIVE and REVERSE – no stopping in Neutral.
3. With engine at idle, shift from NEUTRAL to DRIVE and leave shift lever in DRIVE for five (5) seconds. After five
seconds, shift back to NEUTRAL position and leave shift lever in NEUTRAL for five seconds. Perform this procedure
ten (10) times (N-D-N-D-N-D...).
4. With the engine at idle, shift from NEUTRAL to REVERSE and leave shift lever in REVERSE for five (5) seconds.
After five seconds, shift back to NEUTRAL position and leave shift lever in NEUTRAL for five seconds. Perform this
procedure ten (10) times (N-R-N-R-N-R...).

Generall takes 100-1000 miles of 1/2 throttle easy drving to adapt failure to allow system to adapt or havy driving will set a 700 cose and system will stop adapting and will basically go into limp mode... It may shift harsh slip or have opther different shift patterns this is normanl while adaping..

A final system scan is required after the road test or if problems are detected during the test drive. If codes are present,compare to original code scan recorded prior to transmission replacement.

Use a scan tool to check for Diagnostic Trouble Codes (DTCs) stored by the ECM and the TCM. Perform diagnostic and/or
repair procedures to correct these codes.no codes no faults the symtoms you are experiencing are the transmission learning..