Frick's Performance Solutions

Got the first attempt at a fully custom 36x60x6 WIY fab block all welded up. Holes are all at 0.6250", 2" center to center. Nice and flat on top. I made the inner slats too long, so the 3' ends aren't exactly square at the corners, but I already corrected the drawings for that.

Next step is toweld the leg plates to the bottom, make a base from 3x3 square tubing and get some adjustable casters.... I'll have my first legit welding table!

#

Finally getting back at it with the SRTroll shop/service van. Got the front suspension and steering all back together. I'm waiting for the coil overs until I get the exact ride height I want so I can fab up the correct length upper ears. Next step is to get some wheels under it and make sure it's where I want. Then to locate and build mounts to the 5.7 hemi. Luckily I'm using the factory 727, so it will locate the engine for me.

Ah yes. I love cutting 0.25" Steel. Like butter!

Cutting some washers for my neighbor. Quick little 400 part rush.