Solo Satoshi
Share
The most trusted place to buy #Bitcoin hardware. Home miners, nodes/servers, and self custody solutions.
06/17/2026
Revision 7 is back in stock! 🔥 The first drop sold out immediately, and we heard you, so here's round two.
100% assembled in the USA, open source, and shipping from Houston, Texas the same day you order. ⚡️
https://www.solosatoshi.com/product/nerdqaxe-plus-plus/
06/16/2026
The new BM1373 miners are getting a lot of attention right now. Before you pay the premium, it's worth asking a simple question: what are you actually getting for the money?
We ran a straight cost-of-ownership comparison, Nexus S1 vs NerdQaxe++ rev7, over three years of 24/7 operation at the U.S. average residential rate of 17.65¢/kWh.
In fairness to the BM1373, it is the more efficient silicon, 10 J/TH against 14 to 17 J/TH, and that advantage compounds at higher power rates and longer horizons.
The hype is loud, but numbers matter.
What happens when you put two BM1370 ASICs on a single Bitaxe? You get the Bitaxe GT. ~2.15 TH/s of solo mining muscle sipping just 43 watts.
Join us as we walk through the full unboxing, Wi-Fi setup, AxeOS, and wallet config step by step. This one's a beast.🔥
https://www.solosatoshi.com/product/bitaxe-gt-gamma-turbo/aff/7364/
06/14/2026
Today on the podcast we've got a special episode with creator of one of Bitcoins most important tools.
The is a pivotal piece of any sovereign bitcoiners toolkit and you can learn all about it today.
Tune in at 1PM EST!
SeedSigner - Open Source Bitcoin Freedom Tech Get your home mining devices here - https://www.solosatoshi.com/aff...
06/13/2026
Bitcoin mining difficulty is set to drop ~10.13% in about an hour.
For solo miners, that's your odds going up. Same rig, same hashrate, but a lower target means a better shot at solving a block.
The lottery just got a little less crowded. Good time to be pointed at the network.
06/13/2026
WE DID IT! 🎉 NerdQaxe++ Revision 7 is COMPLETELY SOLD OUT!
Wow. Just... WOW. We are absolutely blown away by the response to Revision 7. This launch exceeded every expectation we had, and it's all because of YOU, the most passionate, dedicated, and supportive community in the entire home mining space! 💙💜
From the first unit to the very last, you showed up in incredible numbers and proved once again that the open-source mining movement is stronger than ever. Every single NerdQaxe++ that ships out represents another hashrate warrior joining the fight. We couldn't be prouder to build alongside you.
For everyone who missed out, don't worry, we've got you! Restock is coming Wednesday, June 17, 2026. Mark your calendars, set your alarms, and get ready. Revision 7 will be back!
Thank you for an absolutely incredible launch. The best is yet to come. 🚀
Don't miss the restock! Sign up for in-stock notifications here: https://www.solosatoshi.com/product/nerdqaxe-plus-plus/
My Bitaxe Gamma was hitting over 60°C at stock settings, hot enough for AxeOS to start throttling hashrate. In this video I replace the thermal paste and drop the ASIC temp by 20°C, bringing it back to 45°C with zero throttling.
If your Bitaxe Gamma is running hot, losing hashrate, or the fan is maxed out but temps won't come down, dried-out thermal paste between the BM1370 ASIC chip and the heatsink is one of the most common causes. Factory paste degrades over time, and most miners should re-paste every 12 to 18 months.
In this step-by-step Bitaxe thermal paste replacement guide you'll learn:
-What thermal paste does and why it dries out.
-The warning signs your Bitaxe needs new paste (temps creeping up 5°C+ with no settings changes).
-How to safely remove the heatsink without damaging the ASIC.
-How to clean old paste with isopropyl alcohol.
-The right amount of paste to apply (a pea-sized dot, more is not better).
-Before and after temperature and hashrate results in AxeOS.
🛒 Thermal paste used in this video:
Thermalright TF7: https://www.solosatoshi.com/product/thermalright-tf7-thermal-paste-2g/aff/7364/
Thermal Grizzly Kryonaut Extreme: https://www.solosatoshi.com/product/thermal-grizzly-kryonaut-extreme-thermal-paste-2g/aff/7364/
Great news home miners! The NerdQaxe++ Revision 7 will be available early (tomorrow)!
Watch our full technical deep dive into everything new with Rev 7 and what sets it apart from earlier revisions.
100% assembled in the USA.🇺🇸
No pre-sales. ❌
Ships straight from Texas. 🤠
Website crash expected!
https://www.solosatoshi.com/product/nerdqaxe-plus-plus/aff/1/
06/11/2026
Heatbit releases Bitair, a portable and sleek air purifier that mines Bitcoin.
✅ HEPA purification that traps 99.97% of dust, pollen, smoke, and pet dander down to 0.3 microns.
✅ A solo Bitcoin miner running 24/7.
✅ Whisper-quiet and sleek enough to sit on your nightstand.
🟧 Check the price, specs, and all the details here: https://heatbit.com/?ref=SOLOSATOSHI
06/10/2026
When open source does the hard work, closed source always seems to show up with a “new idea.”
Click here to claim your Sponsored Listing.
Category
Website
Address
1030 Outpost Drive Suite A4
Conroe, TX
77304
Opening Hours
| Monday | 9am - 5pm |
| Tuesday | 9am - 5pm |
| Wednesday | 9am - 5pm |
| Thursday | 9am - 5pm |
| Friday | 9am - 5pm |
