Rotating D-Ring LLC

NOTE MEASURE YOUR STAKE POCKET BEFORE ORDERING TO INSURE PROPER FIT. SOME TRAILER POCKETS ARE DIFFERET SIZES. CONTACT US FOR SIZES TO FIT YOUR JOB.
Rotatingdrings.com

Rotating D-Rings Conestoga Stake Pocket Rotating D-Ring Tie Downs are a Patented system with a 12000lb WLL. Our D-Ring systems are made in the United States and Veteran owned. This system is designed with the idea to allow the Conestoga tarping system to move back and forth while using the tie downs. The top plate is offset to one side allowing the rollers to roll past the tie down. The base is a 3" X 1.0" X 6" Rectangular tube with a 3/8" plate attached to the top of it and a second 3/8" plate attached to the top of it with a pin system between the two that allows the top plate to rotate. Attached to the second 3/8" plate is a 5/8" forged D-Ring. The pin allows the D-Ring to rotate 360 degrees allowing the D-Ring to be pointing in the proper direction to insure the strongest possible holding. Not included due to your personnel preface is the 1/2" pin to secure it into the pocket.

Slide our system into a stake pocket of your Conestoga trailer to keep from having to get on and off the trailer while securing your loads. The Conestoga stake pocket is made because of the reduced space in the stake pocket where the tarping system attached to the trailer.

By having our system attached to your vehicle you don't have to worry about someone removing the shackle from you bumper and not have a way of hooking a rope or cable to it when it is needed.

Rotating D-Ring LLC