Astrolithic

Final assembly for submission to

Two-Headed Sqarg Attack!!!

A few parts didn't make it into the final build because they ended up not really working together. But the sqargnado siren will live on as a terrain piece at least.

I'm going to take a few days to clean up some half assembled bits on my desk before going back into to paint this monster.

I'm also planning another diorama build using my models from last year.

Stay tuned

-Astrolithic

It took far too long to merge these parts, and then slice it again. BUT... the Two-Headed Sqarg is finally printing.

Test Print #1 was a success!

Lady Malys from .miniatures and some cables and wired from

I got lucky and it got much warmer yesterday than I think it was supposed to. The studio stayed at my minimum safe temp for printing. I ran a space heater this morning for a bit of padding and started a larger test print.

With any luck I'll have my Two-Headed Sqarg printed tomorrow!