Dillon Technology Systems LTD

To configure your router for cable internet connection with Smart Wizard:

1. Connect your modem to the internet port of the NETGEAR router and your computer to any of the four LAN ports.

Image
2. Switch the computer, router, and broadband/cable modem, off and on again. Wait for them all to finish booting up.
3. Open a web browser and type the router's IP address which would be either http://192.168.0.1 or http://192.168.1.1 in the address bar and press Enter.
You are prompted to log into the router.
The default username is admin and the default password is password.
The username and password are case-sensitive.
If the default username and password is not working, you might have changed the password. Please try other passwords that you might have changed to. Otherwise, a factory reset is needed to restore the router to factory defaults. To perform a factory reset, see Restoring a NETGEAR home router to the factory default settings.
4. Click Setup Wizard.
5. The Setup Wizard screen displays.
Select Yes and click Next.

Image
6. The Setup Wizard detects the type of internet connection. For cable internet connections, the Setup Wizard detects Dynamic IP.
7. Click Next. The router saves the settings.

Image
Note: Do not change the default settings unless your internet service provider gave you specific DNS information that must be configured.

(Optional) To check if you are connected to the internet, select Router Status under Maintenance.

Image

Look at the IP Address field to see if you have a valid IP address (that is, not blank or filled with zeroes, such as 0.0.0.0).